Removing a hand trim re-exposed the plant offset it had been silently compensating - and a slope scan told bias from sensitivity
hand-trims-hide-plant-offsets.Treat hand-tuned trims as undocumented plant measurements: before deleting one, find what it compensates and re-house that knowledge in the model or the reward budget; diagnose posture errors with a sensitivity sweep to distinguish constant bias from gain problems.
Symptom
After switching from the old hand-trimmed default to the clean geometric zero, the retrained stand policy's only regression was torso lean: 1.8 deg -> 4.1 deg backward.
Context
The old default's ankle-pitch trim (-0.0489/+0.0628) had been pre-compensating a fore-aft COM mismatch; removing the trim removed the hidden compensation, and the posture reward alone was too weak to win it back. A COM sensitivity scan settled what kind of problem this was: sweeping base COM offset -50 to +50 mm gave nearly identical slopes for old and new policies (~0.026 deg/mm) - "不是质心敏感度问题, 是恒定偏置" (not a sensitivity problem, a constant bias). Fix landed in stand_v1b: posture corrected to +0.24 deg while keeping symmetry (<=0.1 deg) and low effort (0.259), disturbance rejection better than both predecessors. Model credibility was checked the honest way: v0's sim prediction at the real COM position (-22 mm) was -2.31 deg lean vs real measured 2.2-3.1 deg - "预测精准命中" - which is what licensed trusting v1b's -0.52 deg prediction. (Side flag from the same file: a sign convention had been documented wrongly in early comments - gravity_base[0] > 0 is forward lean.)
Change
Trims retired in favor of explicit modeling: symmetric geometric default plus a posture-reward budget sized to carry the real COM offset; the offset itself known (real COM ~22 mm behind model).
Outcome
stand_v1b passed acceptance as the standing lineage's final version; the walk-line requirement "加大躯干姿态惩罚权重" was upgraded from suggestion to mandatory, since walking amplifies what standing tolerates (real walk_v1 hit 26 deg lean vs sim 7.4).
Mechanism
Hand trims are plant knowledge stored in the wrong place - invisible, asymmetric, and stale after recalibration; removing them re-exposes the raw plant error. A sensitivity sweep separates the two possible diagnoses (slope change = control problem; parallel offset = constant plant bias), each with a different fix.
Applies when
- cleaning up hand-tuned offsets/trims in defaults or calibration
- a posture bias appears after a default or calibration change
- deciding whether a lean is a COM-sensitivity or constant-offset issue
“两者斜率几乎相同(≈0.026°/mm),v1 只是整体多后仰约 2.4° —— 不是质心敏感度问题,是恒定偏置。成因:旧 default 的踝俯仰 trim(−0.0489/+0.0628)本就预补偿了前后质心偏差,换成零位 default 后这份补偿没了 … v0 在真机质心处(−22 mm)的 sim 预测为 −2.31° 后仰,真机实测 2.2~3.1° 后仰 —— 预测精准命中。”