Skip to content
MouseMouse

Prone get-up sat at 0/159 until two gated hinge terms moved the seated feet - first sideways (561 -> 360 mm), then fore-aft (-168 -> +56 mm) - and success went to 158/159 with nothing else changed

A lesson the Coach cites as prone-dead-end-is-foot-placement.
Mechanism understoodReward design

When a stuck state and a successful state differ geometrically, penalize the discriminating quantity with a gated hinge that is exactly zero in the state the policy actually reaches (measure it - not the nominal), then re-probe: flattening one axis can move the discriminant to another.

Symptom

Prone falls always righted and then sat with the feet splayed wide or tucked behind the hips, from where the policy never stood (0% for four generations).

Context

Four lines of evidence pointed at foot position: the configuration probe (ankles 215 mm apart stood 52.3%, 561 mm apart 0.0%); FK showing the action contract's nominal (a = 0) is itself a 465 mm straddle, so the action_rate and still terms were pulling toward the splits; biomechanics (feet tucked under the body cut peak hip-extension torque 148.8 -> 32.7 N*m, -78%); and HoST's foot-displacement term, which this reward table lacked. The earlier "not a reward hole" reading was corrected to "a gradient hole, not a level hole": at the dead point the heaviest term (upright) was saturated with zero gradient, still paid for not moving, and the one live gradient (base_height) pointed at the thigh-horizontal torque barrier. A prone ROM scan had already ruled out pushing up from prone.

Change

R0.4: feet_spread_excess = clamp(ankle distance - 0.215, 0, inf) x upright gate, weight -2.0, plus a height-decay factor added after measuring that the policy's real standing stance was 406 mm, not the 215 mm nominal (the plain version would have taxed every successful stand 0.38/s). R0.5: the same shape on the fore-aft axis, feet_fore_seated = |fore-aft offset - 0.05| x upright gate x height decay, target +50 mm (the measured natural offset of standing postures). One variable per rung.

Outcome

R0.4: seated ankle distance 561 -> 360 mm, supine/side exactly unchanged, prone 0 -> 1.9%, mid 45.9 -> 62.2%; a probe then showed the discriminant had moved to the fore-aft axis (standing starts +42 to +51 mm, the prone seat -168 mm). R0.5: supine 99.4, prone 99.4, side 100, mid 100%, re-falls 0%; both geometry terms collapsed to ~0 near iteration 13,100 as base_height rose, and the prone fore-aft offset went -168 -> +56 mm - the term's own target, closing the causal chain. The cost, unmeasured at the time: action jitter rose 33% (sum |da|^2 6.82 -> 9.06).

Mechanism

An upright-gated hinge is inert while the robot rolls and exactly zero in the achieved stance, so it adds gradient only inside the stuck basin; a seated robot with its feet behind or outside its COM must make a kinematically unfavourable transition to stand, and moving the feet under the body removes it.

Applies when

  • a get-up or transition skill fails from one start category only
  • successful and failed episodes differ in a measurable geometric quantity
  • a shaping term might tax the posture successful episodes already use
“`recovery_r0_5`,唯一变量 = 追加 `feet_fore_seated`(与 R0.4 同形状,只换测量轴)。 … 对照 R0.4 的 prone(3.1%,360 mm,**−168 mm**):前后偏移从 −168 走到 +56, 正是这一项的目标量,**判别量被消掉后成功率随之到顶** —— 因果链完整。”
git:Lucen-recovery@origin/recovery:train/RECOVERY_V0_SPEC.md § §20 R0.5(前后向脚位置项):成功率门全过 —— prone 0/159 → 158/159

Principles that cite it