Isaac splits Coulomb friction into static and dynamic columns - wiring only static means zero loss during motion, silently discarding the identified value
sim-api-friction-columns.When installing identified actuator parameters, map each measured quantity to the simulator's exact API column for the operative regime (dynamic for moving loss, viscous for damping), verify per joint after landing, and audit how randomization intervals fall on each column's nominal.
Symptom
The hardware-identified Coulomb friction (tau_c) was about to be installed into the trainer through the friction= field alone - which in Isaac 5 populates only STATIC friction, so during motion the joints would lose no torque at all: "只给 static 则运动中不损耗, 辨识的 τ_c 走路时等于没接" (the identified tau_c would effectively not be connected while walking).
Context
The v12 integration wired all three columns deliberately: armature= and friction= from the 2026-08-04 hardware identification, PLUS dynamic_friction= (Isaac 5 splits Coulomb into static/dynamic; the moving-loss column is dynamic) and viscous_friction= (= the measured joint damping 0.02, aligned to MJCF's damping). Each value was re-checked per joint after landing. A DR interaction was audited and booked rather than hidden: randomize_joint_parameters jitters ALL friction columns with ONE interval - the [-0.05, +0.10] band was calibrated against the Coulomb nominal, and landing on the viscous nominal 0.02 it becomes [0, 0.12], "偏宽但保守" (wide but conservative), accepted with the note that pre-viscous behavior was already [0, 0.10] on a base of 0.
Change
Measured actuator parameters installed across all applicable API columns (armature, static, dynamic, viscous), with the DR side effect on shared randomization intervals audited and recorded.
Outcome
The first generation where the identified plant actually acts during motion in the trainer; the silent-column failure mode documented before it cost a training run.
Mechanism
Physics engines decompose "friction" differently (single coefficient vs static/dynamic/viscous columns); a measured parameter is only installed when it reaches the column the solver reads in the regime that matters (motion, not stiction). Randomizers that share one interval across columns rescale the band by each column's nominal - a hidden unit change.
Applies when
- installing identified friction/armature into any trainer
- porting plant parameters between simulators or engine versions
- joint losses in sim do not match bench measurements during motion
“并额外传 dynamic_friction=(Isaac 5 把库仑拆 static/dynamic 两列,只给 static 则运动中不损耗,辨识的 τ_c 走路时等于没接)与 viscous_friction=(= joint_damping 0.02,对齐 MJCF damping)。… randomize_joint_parameters 用同一个 friction 区间抖三列, [-0.05,+0.10] 是按库仑标称标的,落到粘滞标称 0.02 上成了 [0,0.12]”